GORMAN-RUPP 14C2-F3L, Manual

Page: 38 / 44

10 SERIES OM-00675
MAINTENANCE & REPAIR PAGE E - 14
Securing Intermediate And Drive Assembly To
Engine
(Figure 4)
Install the shaft key (25, Figure 3) in the shaft key­
way. Position the flexible portion of the coupling as­
sembly (3) on the shaft as shown in Figure 4.
NOTE
The flexible portion of the coupling must be proper­
ly positioned on the shaft. The heads of the caps­
crews in the center of the coupling
must be posi­
tioned toward the pump end of the shaft .
Align the keyway in the bushing (3) with the shaft
key, and slide it onto the shaft until it is
just flush
with the end of the shaft. Rotate the flexible portion
of the coupling until the tapped holes for the two
setscrews align with those in the bushing, and in­
stall the setscrews.
Make certain that the flexible portion of the
coupling is mounted as shown in Figure 4.
This is critical. If the coupling is not prop­
erly positioned on the shaft, the coupling
parts may not fully engage, or a pre‐load
condition can cause premature bearing
failure.
The end of the shaft must be recessed
0.41 inch (10,4 mm) from the face of the
bushing. This will allow the two portions of
the coupling to fully engage when the inter­
mediate is secured to the engine bellhous­
ing, without pre‐loading the bearings.
With the flexible portion of the coupling and the
bushing properly positioned on the shaft, tighten
the two setscrews in an alternating sequence until
the bushing and coupling are fully secured. Torque
the setscrews to 14.6 ft. lbs. (175 in. lbs. or 2 m.
kg.).
If the complete coupling assembly is being re­
placed, apply `Loctite Retaining Compound No.
242' or equivalent to the threads of the hardware (4
and 5), and secure the outer ring of the coupling to
the engine flywheel by torquing the hardware to 45
ft. lbs. (540 in. lbs. or 6,2 m. kg.).
Using a suitable lifting device, position the as­
sembled coupling, intermediate, shaft and bear­
ings so the flexible portion of the coupling seats in­
side the outer ring attached to the engine flywheel.
NOTE
To ease installation, lightly lubricate the rubber por­
tion of the coupling with a non‐petroleum based
lubricant such as vegetable oil or glycerin, or a sili­
con‐based lubricant such as “WD40” or equivalent.
Do not use petroleum‐based lubricants, or any oth­
er substance which may soften or otherwise dam­
age the rubber.
Install the intermediate guards (28, Figure 3), and
secure the intermediate to the engine bellhousing
with the hardware (6 and 7).
Seal Reassembly and Installation
(Figures 3 and 6)
Clean the seal cavity and shaft with a cloth soaked
in fresh cleaning solvent.
Most cleaning solvents are toxic and
flammable. Use them only in a well ven­
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain­
ers.
The seal is not normally reused because wear pat­
terns on the finished faces cannot be realigned
during reassembly. This could result in premature
failure. If necessary to reuse an old seal in an emer­
gency,
carefully wash all metallic parts in fresh
cleaning solvent and allow to dry thoroughly.
Handle the seal parts with extreme care to prevent
damage. Be careful not to contaminate precision
finished faces; even fingerprints on the faces can
shorten seal life. If necessary, clean the faces with a
non‐oil based solvent and a clean, lint‐free tissue.
Wipe
lightly in a concentric pattern to avoid
scratching the faces.