OM-05498
SUPER T SERIES
MAINTENANCE & REPAIR
PAGE E - 11
When installing the bearings onto the
shaft,
never
press or hit against the outer
race, balls, or ball cage. Press
only
on the
inner race.
Secure the outboard bearing on the shaft with the
bearing retaining ring (21).
It is recommended that a sleeve be positioned
against the inboard oil seal (7) to prevent the lip of
the oil seal from rolling as the shaft and bearings
are installed in the bearing housing. The O.D. of the
sleeve should be just smaller than the bearing
housing bore, while the I.D. of the sleeve should be
just larger than the O.D. of the lip seal area of the
shaft.
With the lip seal sleeve in place, lubricate the lip
seal area of the shaft and slide the shaft and as
sembled bearings into the bearing housing until
the retaining ring on the outboard bearing seats
against the bearing housing. Remove the lip seal
sleeve.
When installing the shaft and bearings into
the bearing bore, push against the outer
race.
Never
hit the balls or ball cage.
Position the outboard oil seal (4) on the lubricated
shaft with the lip positioned as shown in Figure 2.
Press the oil seal into the bearing housing until the
face of the seal is just flush with the machined sur
face on the bearing housing.
Press the oil seal (7A) into the bearing cap (19) with
the lip positioned as shown in Figure 2. Replace
the bearing cap O‐ring (20) and secure the bearing
cap with the hardware (17 and 18).
Be careful
not
to damage the oil seal lip on the shaft keyway.
Lubricate the bearing housing as indicated in
LU
BRICATION
.
Seal Installation
(Figures 2 and 5)
Most cleaning solvents are toxic and
flammable. Use them only in a well ven
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain
ers.
Clean the seal cavity and shaft with a cloth soaked
in fresh cleaning solvent. Inspect the stationary
seat bore in the seal plate for dirt, nicks and burrs,
and remove any that exist. The stationary seat bore
must
be completely clean before installing the
seal.
A new seal assembly should be installed
any time
the old seal is removed from the
pump. Wear patterns on the finished faces
cannot be realigned during reassembly.
Reusing an old seal could result in prema
ture failure.
The seal is not normally reused because wear pat
terns on the finished faces cannot be realigned
during reassembly. This could result in premature
failure. If necessary to reuse an old seal in an emer
gency,
carefully
wash all metallic parts in fresh
cleaning solvent and allow to dry thoroughly.
Inspect the seal components for wear, scoring,
grooves, and other damage that might cause leak
age. If any components are worn, replace the com
plete seal;
never mix old and new seal parts
.
If a replacement seal is being used, remove it from
the container and inspect the precision finished
faces to ensure that they are free of any foreign
matter.
To ease installation of the seal, lubricate the shaft
sleeve O‐ring and the external stationary seat O‐
ring with a very
small
amount of light lubricating oil.
See Figure 6 for seal part identification.
