679870
56
TROUBLESHOOTING AND ERROR TABLE
Problem/
error
Indication on the display unit and
problem description
What to do?
E0
Incorrect settings
Restart the programme. If the error reoccurs,
call a service technician.
E1
Temperature sensor error.
Inlet water too cold. Repeat the washing
programme.
If the washing machine reports this error again,
call a service technician.
E2
Door lock error.
Make sure the washing machine door is closed.
Unplug the power cord from the outlet; then,
plug the power cord back into the outlet and
switch on the washing machine.
If the error reoccurs, call a service technician.
E3
Water filling error.
Check the following:
• is the water inlet valve open,
• is the filter on the water supply hose clean,
• is the water supply hose deformed (clipped,
clogged etc.),
• is the pressure in the water mains between
0.05 and 0.8 MPa (0,5–8 bar).
Then, press the (3)
START
/PAUSE button to
resume the programme. If the error reoccurs,
call a service technician.
E6
Water heating error
Restart the programme. If the error reoccurs,
call a service technician.
E7
Water draining error
Check the following:
• is the pump filter clean,
• is the discharge hose clogged,
• is the drain clogged,
• if the discharge hose placed is placed below
the maximum and above the minimum
height (see chapter »INSTALLATION AND
CONNECTION/ Connecting and securing the
water discharge hose«);
then, press the (3)
START
/PAUSE button
again. If the error reoccurs, call a service
technician.
E9
Water detected at the bottom of
the washing machine (Total Aqua
Stop system)
Turn off the appliance and turn it back on.
If the error reoccurs, call a service technician.
679870en.indd 56
679870en.indd 56
25. 02. 2021 09:44:56
25. 02. 2021 09:44:56
