Gorenje WA61052, Instructions For Use Manual, Page: 6 / 24

141344
• If you have a tumble dryer of the same dimensions, you can
place it on top of the washing machine.
To ensure correct operation of the appliance, water
pressure inlet must be between 0,05 and 0,8 MPa.
Minimum water pressure can be established by
measuring the quantity of poured out water. 3 litres of
water must be poured out from completely opened tap
in 15 seconds.
• Insert the gasket with screen into the water inlet hose thread
Screw the hose thread to the water faucet
• In case of hot and cold water connection, connect one hose to
cold and other to hot water faucet as marked at the rear of the
appliance (letters C and H) (C - cold; H - hot)
• Fix the outlet hose to run into the sink or the bathtub, or
connect it directly to the wall drain outlet (diameter min. 4 cm).
• Wall drain must be installed properly and must enable
occasional cleaning.
• Fasten the outlet hose support with a piece of rope led through
the hose elbow, to prevent the hose from slipping to the fl oor.
The end of outlet hose should be placed between minimum 60
cm and maximum 100 cm above the fl oor level.
• Plug the mains power cable to the wall mains socket.
• Required voltage and other information are written on the
rating plate above the door opening of the machine.
The wall socket must be accessible at all times and
must be equipped with an earth lead (in accordance
with the local safety regulations).
The permanent connection must be fi tted by an
authorized personnel only.
Water inlet connection Water inlet connection
Water outlet connection Water outlet connection
Connect the appliance to
the mains supply Connect the appliance to
the mains supply
6