4
ASSEMBLY INSTRUCTIONS
Unpack your heater and find the wheel-holding plate and butterfly nuts between the fins assemblies .
1.) Make sure the heater is unplugged.
2.) TURN THE HEATER UPSIDE DOWN.
3.) Connect and tighten two wheel carrier plates to
the body with butterfly nuts as shown in the figure.
4.) TURN THE HEATER UPRIGHT. Your heater is now
ready to use.
OPERATION INSTRUCTION
ON/OFF
Plug in the power, clockwise turn the thermostat knob to the "
" mark position, then turn
on the power switch, the heater starts to work. Stop the heater: turn the power switch to
indication point "0", and then pull out the power plug,
Power selection
Under normal circumstances, please use the maximum power "III" gear for rapid heating. If
the room temperature reaches a suitable temperature, please choose a lower power "II" or "I"
gear to reduce energy consumption so as to prevent the room becoming overheated.
Temperature adjustment
During use, if you feel it is necessary to lower the room temperature since it is too high, you
can use the following adjustment modes:
1.
Turn the power switch to gear "II" or "I".
2.
Counter clockwise turn the thermostat knob back by a certain angle, for which it
indicates that the set temperature is lower when the temperature indication is
closer to the "
" position.
Movement of the heater
To move the heater, turn it off first, and pull out the power plug; then push the body to make
the four casters below the body to roll.
Note:
To use the machine for the first time or to re-insert the socket, please pay attention to check
whether the plug and the socket are fitted well.
E
N