9
AIR CONDITIONER FEATURES
5. MODE select button
Selects the appropriate operating mode. Each time you press the button, a
mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN
and HEAT (cooling only models without). The mode indicator light
illuminates under the different mode settings.
6. TIMER button
Used to initiate the AUTO ON start time and AUTO OFF stop time program,
in conjunction with the & buttons. The timer on/off indicator light illuminates
under the timer on/off settings.
7. SWING button
(Applicable to the models with auto swing feature only) Used to initiate the
Auto swing feature. When the operation is ON, press the SWING button can
stop the louver at the desired angle.
8. LED display
Shows the set temperature in "°C" or "°F" and the Auto-timer settings. While
on DRY and FAN modes, it shows the room temperature.
Error codes and protection code:
•
E1 – Room temperature sensor error - Unplug the unit and plug it back
in. If error repeats, call for service.
•
E2 – Evaporator temperature sensor error - Unplug the unit and plug
it back in. If error repeats, call for service.
•
E3 – Condenser temperature sensor error - Unplug the unit and plug
it back in. If error repeats, call for service.
•
E4 – Display panel communication error - Unplug the unit and plug it
back in. If error repeats, call for service.
•
P1 – Bottom tray is full - Connect the drain hose and drain the
collected water away. If protection error repeats, call for service.
9. FOLLOW ME / TEMP SENSING feature (optional)
NOTE: This feature can be activated from the remote control ONLY. The
remote control serves as a remote thermostat allowing for the precise
temperature control at its location. To activate the Follow Me/Temp Sensing
feature, point the remote control towards the unit and press the Follow
Me/Temp Sensing button. The remote display is actual temperature at its
location. The remote control will send this signal to the air conditioner every
3 minutes interval until press the Follow Me/Temp Sensing button again. If
the unit does not receive the Follow Me / Temp Sensing signal during any 7
minutes interval, the unit will beep to indicate the Follow Me/Temp Sensing
mode has ended
.
10. POWER MANAGEMENT feature When the ambient temperature is lower
(Cooling mode) or higher (Heating mode) than the setting temperature for a
period of time, the unit will be automatically operate power management
feature. The compressor and fan motor stop and the power management
indicator light illuminates. When the ambient temperature is higher (Cooling
mode) or lower (Heating mode) than the setting temperature, the unit will be
automatically quit the power management. The power management
indicator light turns dark and the compressor and (or) fan motor run.
Summary of Contents for KAM PD Series
Page 138: ...5...
