Gorenje K97320AX, Manual, Page: 21 / 23

21
ELECTRICAL CONNECTION
The electrical connection must be carried out in
accordance with the current standards and laws
in force.
Before connecting check that:
• The system and electrical sockets amperage is
adequate for the appliance maximum power (see
data label affixed on the back of the cooker).
• The socket or system has an effective earth
connection in accordance with current standards
and prescriptions of the law. All responsibility is
disclaimed if this is not complied with.
• The plug and socket or the multipolar switch must
be accessible after installation of the appliance.
• I f the appliance has no power cable, connect one
with a suitable cross section to the terminal board
(see paragraph « CONNECTING THE POWER
CABLE»).
When connecting to the mains with a socket:
• Fit to the power cable (if without) a standardized
plug, suitable for the load which is indicated on the
data label. Connect the wires making sure they
correspond as shown below, and remember that
the earth wire must be longer than the phase
wires:
letter L (phase) = brown wire
letter N (neutral) = blue wire
symbol (earth) = green/yellow wire
• The power cable must be laid so that no parts of it
ever reach a temperature of 75 °C.
• For connecting do not use, adapters or shunts
as they could cause false contacts resulting in
hazardous overheating.
When connecting directly to the mains:
• Install a multipolar switch that can withstand the
appliance load, with a minimum opening between
the contacts of 3 mm.
• Remember that the earth wire must not be cut out
by the switch.
INSTRUCTIONS FOR THE INSTALLER
REPLACING THE ELECTRICAL COMPONENTS
• The rear protection will have to be removed in order
to change the electrical heating elements, spit
motor, terminal board and power cable.
• If you have to change the power cable (see the
cross section on table paragraph «TECHNICAL
FEATURES ») , always keep the earth wire longer
than the phase wires and, in addition, follow
all the instructions given in the «ELECTRICAL
CONNECTION» paragraph.
• To change the oven lamp see the instructions on
the REPLACING THE OVEN LAMP paragraph .
• To change the lamp holder , remove the side
panels and then use a screwdriver to push the two
locking tabs (fig. 18) and remove the lamp holder
from the inside of the oven.
• To change the eventual programming accessory,
the thermostat, the commutator and the indicator
lights, remove the front panel as indicated in
paragraph «TAPS»
18