Gorenje K15DWS, Instruction Manual

Page: 14 / 44

14
The kettle is only meant for boiling water.
Do not use it to heat up soup or other
liquids or jarred, bottled or tinned food.
Boiling water can cause serious burns.
Be careful when the kettle contains hot
water.
Never fill the kettle beyond the maximum
level indication. If the kettle has been
overfilled, boiling water may be ejected
from the spout and cause scalding.
Do not open the lid while the water is
boiling. Be careful when you open the lid
immediately after the water has boiled:
the steam coming out of the kettle is very
hot.
Avoid touching the body of the kettle, as
it gets very hot during use.
Always lift the kettle by its handle.
Always make sure the water in the kettle
at least covers the bottom of the kettle to
prevent the kettle from boiling dry.
Some condensation may appear on the
base of the kettle. This is perfectly
normal and does not mean that the kettle
has any defects.
Depending on the hardness of the water
in your area, small spots may appear on
the heating element of your kettle when
you use it. This phenomenon is the result
of scale build-up on the heating element
and on the inside of the kettle over time.
The harder the water, the faster scale
will build up. Scale can occur in different
colours. Although scale is harmless, too
much scale can influence the
performance of your kettle. Descale your
kettle regularly by following the
instructions given in the chapter
‘Descaling’.
Electromagnetic fields (EMF)
This Gorenje appliance complies with all
standards regarding electromagnetic fields (EMF).
If handled properly and according to the
instructions in this user manual, the appliance is
safe to use based on scientific evidence available
today.
This appliance is marked according to the
European directive 2012/19/EU on Waste
Electrical and Electronic Equipment
(WEEE).
This guideline is the frame of a European-
wide validity of return and recycling on
Waste Electrical and Electronic Equipment.
Boil-dry protection
This kettle is equipped with boil-dry protection.
This device will automatically switch the kettle off if
it is accidentally switched on when there is no
water or not enough water in it. The on/off switch
will
stay in ‘on’ position, but the power-on light ring
will go out
. Set the on/off switch to ‘off ’ and let the
kettle cool down for 10 minutes. Then lift the kettle
from its base to reset the boil-dry protection. The
kettle is now ready for use again.
Before first use
1. Remove stickers, if any, from the base or kettle.
2. Place the base on a dry, stable and flat surface.
3. Rinse the kettle with water.
4. Fill the kettle with water up to the maximum level
and let it boil once
(see ‘Using theappliance’).
5. Pour out the hot water and rinse the kettle once
more.
Using the appliance
1. Open the lid by pressing the lid release button.
2. Fill the kettle with water.
You can fill the kettle either through the spout or
through the open lid.
3. Close the lid.
Make sure that the lid is properly closed to prevent
the kettle from boiling dry.
4. Place the kettle on its base.
5. Put the plug in the wall socket.
6. Set th
e on/off switch to ‘I’.
The power-on light ring goes on and the kettle
starts heating up.
The kettle switches off automatically when the
water has reached boiling point.
Cleaning and descaling
Always unplug the appliance before cleaning it.
Do not use any abrasive cleaning agents, scourers
etc. to clean the kettle.