50
3909
Models with two gas burners:
• On the knobs, heating power levels are indicated with
thick and thin markings. Rotate the knob past the asterisk
( ) position and the thick markings to the thin markings
position and back. Operating position is within the range
indicated by the markings.
• Settings between ( ) and ( ) are not recommended. In
this range, the fl ame is unstable and may be extinguished.
Before rotating the knob, it should first be depressed.
Single-handed ignition
• To ignite a gas burner, press the corresponding knob and
rotate it to the maximum power position. Electric spark
from the spark plug will be activated and the gas will ignite.
• Electric ignition will only work if the power cord is
connected to the power mains. If electric ignition does not
work due to a power supply failure or damp spark plugs,
the gas can still be ignited with a match or a lighter. After
ignition, keep the knob depressed for approximately 10
more seconds until the fl ame is stabilized.
If the burner hasn’t ignited after the knob has been
depressed for fifteen seconds, close the burner and
wait at least one minute. Then, repeat the ignition
process.
If the burner flame is extinguished (for any reason),
close the burner and wait at least one minute before
attempting to re-ignite it.
• To extinguish the fl ame and close the burner gas supply,
rotate the control knob to the right, to the ‘OFF’ position
( ).
Ignition and operation
of the burners
10
OPERATING THE GAS BURNERS
