16
This equipment is labelled in compliance with
the European Directive 2012/19/EC on waste
electric and electronic equipment
–
WEEE. The
Directive specifies the requirements for
collection and management of waste electric
and electronic equipment effective in the entire
European Union.
Preparation for use
1. Remove the packaging.
2. Clean the appliance as instructed in the section
"Cleaning".
3. Fill the water tank up to the MAX marking with
clean uncontaminated water. Water in the tank
should not reach the ice basket.
Fill the appliance with water at room
temperature.
Use
Upon first use, it is recommended for hygienic
reasons to discard the ice cubes made from the
first two cycles.
= POWER
= SELECT
= L (large)
= S (small)
= ICE FULL
= ADD WATER
After connecting the appliance to the
power mains, the indicator on the
POWER button will flash in red. Flashing
of the indicator means that the
appliance is in standby mode. Press the
button to start the appliance. The indicator will be lit
continuously. If your press the POWER button at
any time during operation, the appliance will switch
back to standby mode and the indicator will start
flashing.
Use the SELECT button to choose the
size of the ice cubes. The indicators
above S (small) and L (large) indicate
the selected option.
If the indicator above the ICE FULL
sign is lit, the ice basket is filled to
capacity. When maximum amount of
ice has been reached, the appliance will switch to
standby mode. Remove the ice from the basket to
restart it.
If the indicator above the ADD WATER
sign is lit, there is not enough water in
the water tank. When there is not
enough water in the water tank, the
appliance will switch to standby mode.
To restart the appliance, remove the ice basket and
add water up to the MAX sign and press POWER.
Depending
on
the
temperature
of
the
environment and water, the first ice cubes may
be smaller.
Due to rapid freezing of the water, the cubes
may appear cloudy, or opaque. This is a result
of the air trapped inside the ice and it does not
affect the quality of the ice.
After the appliance has been switched to
standby mode, wait for at least 3 minutes
before starting its operation. Failure to do so
may result in compressor failure.
Replace the water in the water tank at least every
24 hours.
To prevent the development of mould and bacteria,
we recommend leaving the cover open after use
(7).
Cleaning
Before cleaning the appliance, stop its operation
and disconnect it from the power mains.
Do not clean the appliance with scouring pads,
caustic or corrosive cleaners or aggressive liquids
like alcohol, gasoline, or acetone.
Clean the appliance with a soft damp cloth. Do not
submerge the unit in water and do not clean it under
running water or in a dishwasher.
Summary of Contents for IMC 1200B
