Gorenje GV65160XXLCUS, Operating Instructions Manual

Page: 16 / 24

Action Possible causes Problem
Remove the arms and clean them. The spray arms do not rotate. The dishes are not clean.
Check that the dishes are not blocking
the spray arms.
Clean the spray arms. See the chapter
Care and maintenance instructions. Spray arm holes or bearings blocked.
Choose a longer program. Unsuitable dishwashing program.
Dose according to water hardness. Far
too much or far too little detergent can
result in poor dishwashing results. Incorrect detergent dosage.
Avoid large packages. Detergent is too old. Detergent is a per-
ishable product.
Do not cover dishes with large bowls or
lids. Avoid placing very tall glasses in
the corners of the baskets. Dishes loaded incorrectly.
Load the dishes securely. Glasses and cups have toppled over
during the program.
Check that the filter handle is locked in
the stop position. The handle should
point straight out from the dishwasher. The filters are not fitted correctly.
Check that the colored stop on the right
in the bottom drain is in place. See the
chapter Care and maintenance instruc-
tions. Drain pump stop missing.
Rinse off these types of food if not start-
ing the dishwasher immediately. Use the
Rinse program. Some types of food, such as mustard,
mayonnaise, lemon, vinegar, salt, and
dressings, can mark stainless steel if left
for too long. Spots on stainless steel or silver.
In order to avoid marks and tarnishing,
separate dishes made from different
metals, such as silver, stainless steel,
and aluminum. All stainless steel can cause spots on
silver if they come into contact during
dishwashing. Aluminum can also cause
spots on dishes.
Check that the salt compartment lid is
properly tightened. Otherwise call the
Customer Care Center. The water softener is leaking salt. Spots or films on the dishes.
See the chapter Settings. Incorrect water softener setting.
See the chapter Settings. Incorrect rinse aid dosage setting.
Top up with salt. See the chapter Before
washing for the first time. Salt compartment empty.
Inactivate the setting TAB (3-in-1/all-in-
one detergent) and top up with salt and
rinse aid. 3-in-1/all-in-one detergent is used and
the setting TAB (3-in-1/all-in-one deter-
gent) is activated.
Wash crystal at a low temperature and
with a conservative amount of detergent.
Contact the detergent manufacturer. Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired,
only prevented.
16