Gorenje FTG 30-100 E5, Instructions For Use Manual

Page: 18 / 24

Operating the heater – manual setting
Temperature is set by pressing button
2
until you get the desired temperature level
(preset temperature level is 57 °C):
- Freeze protection, temperature about 10 °C
- Water temperature about 35 °C.
- Water temperature about 57 °C.
- Water temperature about 75 °C.
Once the maximum level " " is achieved, pressing the
2
button returns the temperature
to the first setting " ".We recommend the " " setting. This setting is the most energy-
efficient. The temperature of water is about 57 °C, while limescale production and heat
loss will be smaller than in case of higher temperature settings.
The temperature of water in the heater is indicated on the display
1
.
If the heater will not be used for a longer period of time, please protect its contents from
freezing by setting the temperature to the " " position. At this setting, the heater will
maintain the temperature of water at about 10 °C.
Functioning of the heater in the "Eco Smart " mode
This mode is appropriate especially if you have well-established hot water consumption
habits (e.g. showering every day at approximately the same time). To start the heater in
the "
Eco Smart" mode, you first have to start recording. During the recording time, the
electronic regulator remembers your habits and takes them into account while heating
the water after the recording period has ended. The recording takes place for 7 days. The
"
Eco
Smart" mode reduces the consumption of electrical energy.
• By pressing button no.
4
the recording of your habits starts. When the recording ends
after 7 days, the recorded regime starts to run automatically. During the recording
period and when the heater is functioning in the "EcoSmart" mode, the green control
light
3
is on.
• By pressing
4
again, you can switch off the recording or the "EcoSmart" function.
The heater resumes to the basic mode of operation. The water is heated to the set
temperature.
• Resuming the "EcoSmart" function can be done by pressing
4
. If the regime has already
been recorded (if the recording was not interrupted) the "EcoSmart" mode starts
running immediately. Otherwise, a new 7-day recording period begins. The green light
3
is on.
• If the electronic regulator has recorded the regime but the user's hot water consumption
habits have changed, a new recording period must be started. It can be started by
holding button no.
4
. The recording period lasts 7 days.
489390
18
EN