340670
Removing frost by thawing
If the frost layer is too thick to be scraped off, it has to be at least
partially melted.
• Remove the plug (1) on the front side of the freezer.
• Insert the supplied tube into the opening (2) an place a container
to collect the water from the melted frost underneath it.
• Remove the plug (3) on the bottom of the freezer.
• Leave the cover open to speed up the thawing process. Use a
soft cloth to wipe the interior surfaces. Replace both plugs and
save the tube for later use.
• Do not use any defrosting sprays as they may melt the plastic
parts or harm your health.
Unplug the appliance from the wall outlet/socket before
cleaning!
Do not use abrasive or aggressive cleaners to avoid damaging
the surfaces.
When cleaning, make sure you remove all and any detergent
residues after you are done.
• Clean the
interior
with a solution of water and some diluted
vinegar or baking soda (1 tablespoon per 1 litre of water).
Finally, wipe all surfaces dry with a clean cloth, rinsed in clean
water and thoroughly wrung.
• Clean the
exterior
using a soft cloth and water with a small
amount of detergent.
To clean the
cover gasket
, use mild soapsuds.
Clean lacquer coated surfaces with a soft cloth and alcohol-
based cleaner (e.g. glass cleaner). You may also use pure
alcohol (ethanol or isopropyl alcohol).
Do not use abrasive cleaners or special aggressive cleaners
such as stainless steel cleaners etc. on plastic and lacquer-
coated parts.
• If your appliance has the condenser unit installed on the back
wall of the appliance, use a soft non-metal brush or a vacuum
cleaner to occasionally (at least once per year) remove the
dust from the condenser unit.
Unplug the appliance, empty it, defrost it, and clean the interior.
Put an open box of baking soda in the appliance interior and
leave the cover ajar.
Cleaning the appliance
Putting the appliance out
of use
13
