Instructions for Use
10
Sound alarm button, The Red Light is On
•
The door was frequently opened or it was left
opened for too long.
•
The door is not properly closed (the door
may sag, the gasket may be polluted or
damaged).
•
Power supply has been interrupted for a
longer period of time.
•
Perhaps you have overloaded the appliance
with fresh foods.
To stop the sound alarm press the alarm
button
.Red light goes off when the
malfunctions are removed and the temperature
within the appliance reaches the appropriately
low level (depending upon the thermostat
setting).
Continuous Operation of the Cooling
System
•
Set the operation mode selection switch
from continuous to automatic operation.
•
The reason may be inadequate ventilation of
the compressor and condenser (assure
adequate air circulation behind the appliance
and wipe the dust from the condenser).
The Door is Hard to Open
If you want to open the door that has just or
recently been closed, you may find it hard to
open. The reason why this happens is, that
when you open the door, warm air gets into the
appliance and when it is cooling, the
underpressure seals the door. After few
minutes (5-10), the door can easily be opened.
Noise
Cooling in refrigerating-freezing appliances is
enabled by the cooling system with
compressor, which produces noise. How noisy
the appliance is depends on where it is placed,
how it is used and how old the appliance is.
•
During the operation
of the compressor the
noise of liquid is heard and when the
compressor is not operating, the refrigerant
flow is heard. This is a normal condition and
it has no influence whatsoever on the
lifetime of the appliance.
•
After starting the appliance,
the operation
of the compressor and the refrigerant flow
may be louder, which does not mean that
something is wrong with the appliance and it
has no influence on the lifetime of the
appliance. Gradually the noise is reduced.
•
Sometimes
unusual and stronger noise
is
heard, which is rather unusual for the
appliance. This noise is often a
consequence of inadequate placing. (The
appliance shall be placed and levelled firmly
on solid base and it should not touch the wall
or kitchen units standing next to it.)
Bulb Replacement
(models with interior illumination only)
Before replacing the light bulb, disconnect the
appliance form the power supply.
Remove the plastic cover with the screwdriver
and replace the bulb with a new one (E14,
max. 15 W). Don't forget: the old bulb does not
belong to organic waste.
Light bulb is consumning good therefore
our in-guarantee service does not relate to
it.
WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO
INFLUENCE ON THE OPERATION OF THE APPLIANCE
.
