background image

Instructions for Use

19

Maintenance and Cleaning

Freezer Defrosting

Frost and ice layer, depositing on the inner
walls of the freezer should be defrosted when
3-5 mm thick.



24 hours before defrosting set the
thermostat knob to the position for
continuous operation (the yellow light is on)
so that the food packages are well cooled.
After that empty the freezer and take care
that the packages don't start to thaw.



Disconnect the appliance from the mains
supply.



Insert the enclosed pipe into the groove in
the bottom of the appliance and place a
vessel underneath to collect the defrost
water. Defrosting is accelerated if the door
is left open.



Avoid using defrosting sprays, as they may
cause damage to the plastic parts and may
be hazardous to health.

Cleaning the Appliance

Before cleaning the appliance disconnect
the cable from the mains supply.

 Do not

use abrasive cleaning agents. Be careful to
remove any cleanser agent remaining after
cleaning.



Clean the 

exterior 

of the appliances with

water and liquid detergent.



Wash the 

interior 

with lukewarm water and

some vinegar.



From time to time wipe the 

condenser 

on

the rear wall with a soft non-metal brush or
vacuum cleaner.

After you have cleaned the appliance,
reconnect it to the mains supply and put the
food packages back to their place.

Switch Off the Appliance When
Not in Use

If you do not intend to use the appliance for a
longer period of time, disconnect the power
supply, empty the appliance, defrost it and
clean it. Leave the door slightly open.

 Trouble Shooting Guide

During the service, you can come across
some troubles that in most cases result from
improper handling of the appliance and can
easy be eliminated.

The Appliance Fails to Operate After
Connecting to the Mains Supply



Check the supply in the outlet socket and
make sure the appliance is switched on.

The Red Light is On



The door was frequently opened or it was
left opened for too long.



The door is not properly closed (the door
may sag, the gasket may be polluted or
damaged).



Power supply has been interrupted for a
longer period of time.



Perhaps you have overloaded the appliance
with fresh foods.

Continuous Operation of the Cooling
System



Set the thermostat knob from the position
for continuos to the position for automatic
operation.

Downloaded from Fridge-Manual.com Manuals

Summary of Contents for F 3101 W










Reviews: