Instructions for Use
14
Storing Time During Power
Supply Interruption
Avoid opening the freezer in case of failure or
power supply interruption! In case the
interruption is extended over longer period of
time (16 hours for ZOS 0721/6, 14 hours for
ZODS 1021/6 and 19 hours for ZOS 1051/6),
take food out of the freezer and use it, or
make sure it remains well cooled (perhaps
you have an extra appliance).
Disposing of the Worn Out
Appliance
When your appliance finally wears out,
dispose it of. If the appliance has a lock,
break it, in order to prevent eventual
accidents (danger of children get locked
inside the appliance).
The refrigerating system of the appliance is
filled with refrigerant and insulating
substances which should be separately
treated and processed. Call your nearest
authorised service agent or specialised
servicing centre. If you don't find one,
contact your local authorities or your
distributor. Be careful not to damage the
tubes on the rear wall of the appliance
(danger of pollution).
Placing and Installation
Choosing the Right Place
Place the appliance in a dry and regularly
ventilated room. Allowed ambient temperature
depends on the model (class) of the
appliance and is stated on the rating plate of
the appliance.
Never place the appliance near heat emitting
devices (e.g. cooker, radiator, water heater
and similar devices) and do not expose it to
direct sunlight.
The appliance should be positioned at least 3
cm away from the electric or gas cooker and
at least 30 cm away from the oil or coal stove.
If this is not possible, use an appropriate
insulation.
Behind the appliance there should be free
space at least 200 cm² wide and above the
appliance the high kitchen units should be at
least 5 cm away from the appliance in order
to assure adequate ventilation of the
condenser unit.
Class
Ambient temperature
SN (sub-normal)
from + 10°C to + 32°C
N (normal)
from + 16°C to + 32°C
ST (sub-tropical)
from + 16°C to + 38°C
T (tropical)
from + 16°C to + 43°C
Placing the Appliance
Place the appliance firmly on a solid base.
Level it with the two adjustable feet, located
on the front.
The appliance with ventilation grid may be
placed close to the wall. The grid enables
sufficient air circulation, required for
adequate ventilation of the rear wall.
Connection to Power Supply
Connect the appliance with the cable and
plug to the power supply socket outlet with a
ground terminal (safety socket).
Required nominal voltage and frequency are
indicated in the rating plate. The connection
to the mains supply and earthing have to be
made according to current standards and
regulations. The appliance resists temporary
voltage tolerance up to -6 to +6 %.
