Gorenje D744BJ, Detailed Instructions

Page: 43 / 48

43
349780
Problem/error Cause What to do ...?
The dryer does
not work. • No voltage in the power outlet. • Check if the power cord plug is
correctly inserted into the power
outlet.
• Check the fuse.
There is voltage
in the outlet, but
the drum does
not spin and the
dryer does not
work. • Program was not started
in accordance with the
instructions.
• The door is not properly
closed.
• Condensate tank is full.
• Delayed start function has
been selected.
• Reread the instructions for use again.
• Push the door towards the appliance.
• Empty the condensate tank (see
section Cleaning and Maintenance).
• Wait until the time indicated on the
display elapses.
Laundry is not
dried, or drying
temperature is
longer than 4h. • Filters are not clean. The room
is not sufficiently ventilated.
• Inappropriate temperature in
the room.
• Laundry was not sufficiently
wrung or spun.
• Amount of laundry dried in
the appliance is too large or
insufficient.
• Clean the filters.
• Check whether water condenser is
cleaned.
• Install the dryer in an appropriate
room (see section Installation ...).
• Check if the temperature in the room
where the dryer is installed is too
high (over 25°C) or too low (below
10°C).
• Laundry inserted into the dryer was
not sufficiently wrung or spun, or an
inappropriate drying program was
selected.
• Use an appropriate program or use
the timed program. Increase the
final level of dryness for the selected
program (intensive drying function).
Poor
condensation • Inadequate location of the
dryer.
• Check whether the ambient
temperature of the room is not too
high.
• Check whether the condenser is clean.
Unevenly dried
laundry. • The amount of laundry dried at
a time is too large.
• Drying the pieces of different
thicknesses.
• Drying the different types of
laundry.
• Make sure the laundry is sorted by
type and size of items given the
selected program (see section Drying
– Preparing the Laundry and the
Program Table).
Error in the drum
lighting. • There is no lighting when the
dryer door is opened.
• Disconnect the dryer from the power
mains and call an authorized service
unit.
On display: F3 • Full condensate tank.
• If the condensate tank is
empty, there is a pump failure.
• Empty the condensate tank (see
section Cleaning and Maintenance).
• Disconnect the appliance and call the
nearest service unit.
On display:F4 • Clogged filters.
• If the filters are clean, there
may be a compressor failure.
• Clean the filters.
• Disconnect the appliance and call the
nearest service unit.
On display:"LO"
• Steam generator tank is empty • Add distilled water.
Write down the failure/error code: F0, F1, or F2, disconnect the appliance and call the
nearest authorized service (call center).