6.
Installing the Tap:
• Select a convenient location near your sink to place the Tap (E1)
• Drill a hole 12mm in diameter in the counter top
(drill & bit not included)
• Place the Cover Plate (E2) and one Rubber Washer (E3) on the Tap
thread as shown below
• Insert the Tap thread into the drilled hole
• Place the other Rubber Washer and Wing Nut onto the Tap thread
under the counter and tighten the Wing Nut as shown below
• Measure the length of White Tubing (D1) needed to join the
bottom of the Tap to the outlet on the Mineral Ball Filter
Housing, then cut the White Tubing to-size if necessary
• Slide the Steel Fastening Nut (D4) over one end of the White
Tubing with the thread facing outwards as shown below (*)
• Place the Transparent Self-Sealing Ring (D2) over this same end
of the White Tubing as shown below (**)
• Place the Transparent Tube Reinforcing Insert (D3) into the end
of the White Tubing as shown below (***)
*
**
***