Hardware
USB 4113/ basicCON 4113 – User Manual
2-5
Addressing individual
USB 4113
boards in the
GOEPEL electronics
USB
Rack
or
basicCON 4113
devices takes place exclusively according to
their serial numbers: The device with the least serial number is always
the device with the number
1
(but counting by considering all other
GOEPEL electronic
s USB devices in the same system).
To improve clarity, we recommend to arrange several
USB 4113
boards (if applicable) in the order of ascending serial numbers
in a
GOEPEL electronics
USB Rack
.
The
USB 4113
board is supplied via the
USB Rack
in that it has been
installed.
Power supply for
basicCON 4113
can be effected via the USB interface
(as far as it is configured for the required current of about 500 mA).
For operating the
basicCON 4113
at passive USB hubs or laptops with
lower power supply, use the two banana females for
ext. Power Supply
(red = plus/ blue = minus)
for supplying the device with a voltage of 7-25 VDC).
Alternatively, you may use the female for the delivered AC adaptor
plug with coaxial power plug (2.1 x 5.5mm/ plus polarity inside),
see also Figure 2-3.
Used connector:
Rosenberger D4S20A-40ML5-Z
Connector for connecting cable (recommened):
Rosenberger D4K10A-1D5A5-Z
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
Out
1
Out
2
Out
3
Out
4
In
Figure 2-5: Front panel USB 4113
The following table shows the pinout of the LVDS females:
Connection Pin
Signal
Connection Pin
Signal
Out 1..4
1
LVDS-
In
1
GND
2
Control
2
LVDS+
3
LVDS+
3
Control
4
GND
4
LVDS-
2.3.3
Addressing
2.3.4
Power
Supply
2.3.5
Connector
Pinout
