SPECIFICATIONS
THIS INFLATOR OPERATES ONLY ON 12 VOLT DC OR THE INTERNAL
BATTERY. DO NOT ATTEMPT TO OPERATE THIS INFLATOR WITH ANY
OTHER SOURCE OR VOLTAGE. DO NOT REWIRE OR RECONFIGURE
INFLATOR FROM ITS ORIGINAL DESIGN OR PERSONAL INJURY OR
BODILY HARM MAY OCCUR.
Voltage
12 V
Power Requirement
DC 12V/12A – For use with 12 Volt DC
Power Outlet Only
Note:
This unit is equipped with fuse protection
. If at some point your Inflator
fails to operate, check the fuse in the end of the 12 volt plug. To replace the fuse,
simply unscrew the 12 Volt power plug tip, install new fuse and reassemble power
plug tip. Use only an AGC - 15 amp replacement fuse.
IMPORTANT SAFETY INFORMATION
WARNING
1.
Use 12 volt DC only. Make sure that your vehicle 12 Volt power outlet is free
of any ash residue or debris. A dirty 12 Volt power outlet can cause the
inflator and power cord to overheat. Overheating can cause damage to your
inflator/vehicle and could cause bodily harm or injury (Disconnect power
when not in use).
2.
This inflator is designed to inflate car tires, bike tires, ATV tires, sports
equipment, air mattresses, beach toys and other inflatables. Do not use for
any purpose other than inflating. If you do so, bodily harm or personal injury
can occur.
3.
When operating your inflator do not run more than 10 minutes continuous
use. Allow inflator to cool down 10 minutes before re-using.
4.
After using, turn off power.
5.
The inflator is not a toy. Keep away from children at all times.
6.
Do not carry inflator by the air hose or power cord or damage may occur.
7.
Do not leave the inflator unattended while in operation.
8.
Do not over-inflate. Please follow the manufacturer’s instructions for the item
you are inflating
9.
Keep the inflator away from flammable areas/liquids at all times.
10.
Do not operate inflator in wet or damp areas.
11.
Operate inflator only with the accessories that are included.
12.
USE SAFETY GLASSES. Also use face or dust mask if operation is dusty.
4
PARTS DIAGRAM
Item # Name
1
12 Volt Plug
2 Pressure
Gauge
3
Power On/Off Switch
4 Removable
Flashlight
5 Valve/Tire
Chuck
6 Rubber
Raft/Air
Mattress Adapter Nozzle
7 Ball
Adapter
Nozzle
OPERATING INSTRUCTIONS
To inflate vehicle tires:
1. Connect the 12 volt plug (1) into 12 V power outlet (cigarette lighter).
2. Connect the Valve/Tire chuck (5) to tire’s air stem valve and push down the
Valve Lock Lever (5) to secure the connection.
3.
Slide the On/Off switch to “On” position and the inflator will begin to operate.
Inflate your tire or desired item to the correct pressure and shut off the inflator by
sliding the On/Off switch to the "off" position.
CAUTION
DO NOT OVER-INFLATE YOUR ITEM
5
