4
GENERAL POWER TOOL SAFETY WARNINGS
e)
Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired before use.
Many
accidents are caused by poorly maintained power tools.
f)
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
g)
Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the work
to be performed.
Use of the power tool for operations different from those intended
could result in a hazardous situation.
h)
Damaged switches must be replaced at a customer service repair centre.
Do not use power tools that cannot be switched on and off.
i)
Do not leave power tools unattended while they are switched on. Always s
witch off the tool and wait until it has come to a full standstill before leaving.
J)
If the mains cable has been damaged, it must be replaced with a special
mains cable.
These can be obtained from the manufacturer or the manufacturer’s
customer service department. The mains cable may only be replaced by the
manufacturer, the manufacturer’s customer service department or equally qualified
persons.
5)
Service
a)
Have your power tool serviced by a qualified repair person using only
identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
b)
Caution! The use of any accessories or additional tools other than those
recommended in this manual may lead to an increased risk of injury. Only
use original replacement parts
SAFETY WARNINGS FOR IMPACT DRILL
1) Make sure that the tool is only connected to the voltage marked on its nameplate.
2) Never use a tool if its cover or any bolts are missing. If the cover or bolts have been
removed, replace them prior to use. Maintain all parts in hood working order.
3) Always secure tools when working in elevated positions.
4) Never touch the blade or other moving parts during use.
5) Never start a tool when its rotating component is in contact with the workpiece.
6) Never lay a tool down before its moving parts have come to a complete stop.
7) Make sure drill bit is securely mounted. An improperly mounted bit is extremely
dangerous since it can fly off or break during drilling.
8) Don’t wear cloth gloves or a necktie since they could become caught in a rotating bit.
9) Hold the tool securely with both hands. If not held securely, accidents or injury may
result.
10) Never touch the chuck or metal body parts when drilling walls, floors or other
surfaces (double insulated drills only).
11) Hearing protection should be worn.
12) Wear ear protectors with impact drills. Exposure to noise can cause hearing loss.
13) Use auxiliary handles supplied with the tool. Loss of control can cause personal
injury.
14) Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
Summary of Contents for GY-DI-10500-1
