Recommended height measurements
fr
om the floor
to top screws (
1
).
Adult male
1300mm
Adult female
1265mm
Children 5-8 years old
928mm
Children 8-11 years old
1028mm
Children 11-14 years old
1108mm
Wheelchair user
1050mm
2. POSITIONING
2.1 Mark the location on the wall with a
pencil. Use the Installation Template to
points (
1
).
2.2. Pre-drill the wall in the marked
locations using a 5/16 (8mm) drill, inset
the plastic anchors and tap flush
to the
wall (
1
).
2.3 Fix the backplate to the wall. Screw to
CAUTION : Before installation decide if the cable entry is to be from the rear
or the above. Follow the relevant instructions. Do not use the backplate as a
guide when drilling.
mark the locations for the four fxing
the wall and secure with the appropriate
fittin
g ( ).
3. INSTALLING THE POWER
CABLE & CONNECTION
TERMINAL BLOCK
1
WARNING: ENSURE POWER IS NOT
CONNECTED
3.1 Pull the cable through the grommet.
Ensure the cable is long enough to route
correctly through the backplate to the
terminal block.
3.2 The cable must sit in the dedicated
channel.
3.3 As shown, connect cable to terminal
block (
3
).
3.4 Screw in terminal block.
3.5 Fix the cable clamp with screw in the
backplate. (
CAUTION : Connect the ground wire to
the terminal block marked “ ”
Do not over-tighten and crush the
power cable.
5. ATTACHING MAIN BODY
5.1 Close the main cover of the backplate
(
5
).
5.2 Insert and tighten the (2) security
screws into the side of the main body
with the service tool as illustrated below.
5.3 Turn power on.
5.4 Test unit for correct operation.
3
4
5
(In case without built in power cable)
2
2
ON
OFF
4. HEATER SWITCH
4.1 Heater switch ON/OFF (
(factory default setting “ON”)
4
).
L N
6mm
3
).
* Model GWHD30NH does not
have heater and heater switch
