UNPACKING / STANDARD ACCESSORIES
1.
Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to
drop the appliance.
3. Use caution when removing the casing. The casing may have sharp edges/
corners which may cut or cause harm.
4. Inspect carefully for any damage that may have occurred during transit. Check
for any loose, missing or damaged parts. If the hand dryer is damaged, promptly
inform the shipper or dealer where you purchased it.
Standard items included with the hand dryer are:
Manual &
Installation template
Main Unit
Service Tool & Reserve Screw
Wall Mouting
anchors
Flat cable clamp
& Screw
-in case without
built in power cable
INSTALLATION
CAUTION
•
Make sure power supply breaker is switched o
ff
.
•
All electrical installation and repair work should be carried out b
y a qualified
electrician or local service Engineer in accordance with current local codes or
regulations.
•
Check that the electrical supply corresponds to that shown on the rating plate.
If the unit is connected to any electrical supply other than stated on the rating
plate of the unit, permanent damage or unsafe operation of the unit may result.
•
The unit must be mount
ed on a flat
vertical wall capable of supporting the full
weight of the unit.
•
Do not use the backplate as a guide when drilling. Ensure no pipe work (gas,
water, air) or electrical cables, wires or ductwork are located directly behind the
drilling/mounting area.
1. UNPACKING
1.1 Place the main cover on a cloth to
avoid marking its surface.
1.2 Remove the (2) security screws
from the main body, using the service
tool provided. Store safely.
1.3 Lift the front cov
er off the main
body.
GWHD
30
/GWHD
30
NH
POWERFUL, ELEGENT, TOUGH
