Attaching the Light
Attaching Flat Panel to Mounting Bracket
Securing Flat Panel to Mounting Bracket
3-Light Setting Slide Switch
The slide switch allows the color temperature to be
adjusted between 3 values: 5000K, 4000K, and 3000K.
NOTE: Default setting is 4000K bright white.
Keep the support-wire hooks attached to the mounting plate. Lift the LED panel up, being careful not to
scratch the ceiling. Carefully align and insert both metal tabs, (on the same side that the support-wires
are clipped on), and insert into the corresponding slots on the LED panel frame .
While keeping the first 2 metal tabs inserted, pivot the panel up and insert the 2
remaining tabs on the opposite side.
1
3000K: Sets light to 3000K warm white
4000K: Sets light to 4000K bright white
5000K: Sets light to 5000K daylight
2
3
DO NOT USE THE “AUTO ROTATING”
SETTING. “Auto Rotating” is used for
display purposes only and not
recommended for normal use.
x1
Push-in
Fastener
Slide the panel until the notch is fully engaged. Slowly release the
fixture, making sure it stays in place.
IMPORTANT: To lock the panel in place, align the holes in the frame and the mounting tab. Insert the
plastic push-in fastener through the hole located on one of the sides of the panel and the adjacent
hole in the mounting plate tab.
Locking hole
6
