RIP (Router Inf
best known and
congestion and
NOTE: RIP m
Addressing mo
and the set the
controlled via th
information from
RIP is a protoco
and CMTS). T
CMTS settings
To enable the C
as the RIP Auth
1.) To turn on R
2.) To specify a
key name = a s
3.) To specify a
key number = a
4.) To change t
interval by defa
MG7540 Cable
Figure 24 RIP config
formation Protocol) is us
d quickest route to given
d delays.
messaging will only be
ode on the Basic – Setup
Wan IP network informa
he ISP. RIP Authenticat
m the end user to preven
ol that requires negotiatio
The ISP would normally s
to match the configuratio
CM/RG to perform RIP, d
hentication Key and 1 as
RIP MD5 Authentication, c
a RIP MD5 Authentication
string value to match CMT
a RIP MD5 Auth Key ID, ty
a number to match the CM
the RIP annoucement in
ault = 30 seconds
Modem User Manual
30
guration
sed in WAN networks to
destination addresses to
sent upstream when r
p page. You must enable
ation! RIP is normally a f
tion Keys and IDs are no
t unauthorized RIP settin
on from both sides of the
set this up because of the
on in the CM/RG.
do the following (this exa
the Key ID):
check the “Enable” box.
n Key String, type “BRCM
TS key name value
ype “1”
MTS key number value
terval, type in a number
identify and use the
help reduce network
running in Static IP
Static IP Addressing
function that is tightly
ormally held as secret
ngs.
network (i.e. CM/RG
eir knowledge of their
ample uses BRCMV2
MV2” for this example.
in seconds.reporting
