MONITORS PROGRAMMING
51
Turn off the monitor to be programmed by holding
pressed the door release push button for one second.
Once off, press the autoswitch-on push button.
While holding pressed the autoswitch-on push button,
simultaneously press the door release push button.
To show that the system is ready for programming, the
door panel will emit a tone and the image will
appear on the monitor. The push buttons can now
be released.
Lift the handset off the monitor.
Press the door panel push button.
At this moment both door panel
and handset will emit tones.
Each apartment must have one master unit only; in case of parallel units configure
them as slaves, whether they are monitors or telephones.
Make a call to check that the monitor has been successfully programmed.
Repeat these steps to program the rest of monitors.
Once the programming has finished, set the programming switch to OFF.
If you don't, the door panel will reproduce a sound to advise that the
system is still into programming mode.
rogramming the Tekna R5 monitors.
P
REMEMBER:
Monitors only need to be programmed when they
are installed in parallel or when there are general door panels.
Locate the configuration dip switch on the back of the door panel
and set switch number 2 to ON.
The door panel will emit a tone to advise that the system has
entered into programming mode.
In systems with more than one door panel, the programming
process shall be done on the master door panel only.
With the handset lifted:
If programming the monitor as master, replace
the handset.
If programming it as slave, press the door release
push button, then replace the handset.
Master
Slave
52
DESCRIPTION OF THE PLATEA TELEPHONE
escription of the T-730/R5 telephone.
D
a
d
c
e
b
a.
b.
c.
d.
e.
f.
g.
Telephone handset.
Speaker grille.
Microphone hole.
Subjection hole.
Telephone cord connectors.
Function push button.
Hook switch.
It is necessary to open the telephone for wiring
and fixing purposes. To open the telephone,
insert a flat screwdriver into the slots and
gently lever as shown in the drawing.
Pass the installation wires through the corresponding hole and connect
them as shown on the installation diagrams. Close the telephone as shown
on the picture. Once the telephone is closed, connect the handset using the
telephone cord and put it on the cradle.
Avoid placing the telephone near sources of heat, in dusty locations
or smoky environments. The telephone can be fixed using an
electrical embedding box or directly on the wall, as shown on the
picture. If the telephone will be installed directly over the wall, drill
two holes of Ø6mm on the specified positions, using 6mm wall
plugs and Ø3.5 x 25mm screws.
g
f
e
unction push button.
F
With the handset lifted, a call can be made to the master porter's exchange
(this
function is only available in installations with general door panels)
. During call
reception and communication processes, it allows lock release activation.
