golmar 4130/AL User Manual Download Page 8

FEHLERBEHEBUNG / TROUBLESHOOTING HINTS

Nichts geht.

Kontrollieren Sie die Spannung an Klemmen SEC am TF-104, sollte zwischen 12-17VAC sein.

Falls nicht klemmen Sie SEC ab und messen nochmals.
lst die Spannung nun korrekt liegt ein Fehler in der Verkabelung vor.
Kontrollieren Sie auf einen Kurzschluß.

Lautstärke passt nicht.

Rdiese lässt sich an der Türstelle einstellen (Seite 2).

Falls Rückkopplung, dann nicht so weit aufregeln.

Türöffnung geht nicht.

Trennen Sie den AC-Türöffner vom Soundmodul und schließen Sie Klemmen '' und 'P' kurz.

Nun sollte die Ausgangsspannung an Klemmen 'CV' und '~ 2' des Soundmoduls 12VAC sein.

Wenn dies der Fall ist, überprüfen Sie den Türöffner und dessen Verkabelung,
sowie die Verkabelung des Terminals 'P' vom Soundmodul zu den Telefonen.
Falls Sie ein Motorschloss oder einen Türöffner mit DC-Versorgung ansteuern,

so verwenden Sie zur Ansteuerung ein 12VAC Trennrelais.

Telefone klingeln nicht und es ist Aussen kein Bestätigungston zu hören.

Prüfen Sie die Klingelsignal-Leitungen ob diese auch auf ‚CP‘ am Soundmodul

angeschlossen sind (nur bei Stadio Plus).

Nothing operates.

Check the output transformer voltage between SEC terminals: it should have 12 to 17Va.c. If 

not, disconnect the transformer from the installation and measure again. If it's correct now,
it means there is a short circuit in the installation: disconnect the transformer from mains 
and check the installation.

Inappropriate audio level.

Adjust the level volumes as shown on page 2. In case of feedback, reduce the audio levels 

until feedback fade out.

Door open function no operates.

Disconnect the lock release from the sound module and short-circuit terminals ' ' and 'P': at 

that moment the output voltage between terminals 'CV' and '~2' of the sound module 
should be 12Va.c. If it's so check the lock release, its wiring and the wiring of the terminal 
'P' from the sound module to the telephones. If these tests don't solve the problem, replace 
the sound module.

No telephones receive the call or acknowledgement call signal is not reproduced.

Check that the call wires and push buttons common terminal are correctly connected to the 

'CP' terminal of the sound module (in case of Stadio Plus door panels only).

Golmar sowie Elektrohandel Eisterer behält sich das Recht auf unangekündigte Änderungen vor.

GOLMAR Vertretung D/A/CH

Elektrohandel Eisterer
Theodor Wimmer Strasse 16
A - 4760 Raab

GOLMAR SPANIEN

GOLMAR S.A.
C/ Silici, 13
ES - 08940- Cornellá de Llobregat

Summary of Contents for 4130/AL









Reviews: