Goldwing Corvus Racer 540 30CC, Manual

Page: 7 / 15

● Sand the area on the horn that fits inside the rudder so the glue bonds better
● Glue the rudder hinges into both the rudder and fin using epoxy glue . Remember to
use Vaseline , use tape to keep it in alignment . on the hinge joint . While drying
● Glue the rudder horns through the rudder with epoxy
;
wipe off excess glue while it is
wet . Use the and bolt while gluing to maintain alignment . While still movable , ball joint
measure that the same , amount pushes out each side . Care needs to be taken here
otherwise your rudder geometry will be incorrect .
● Assemble the rudder servo control arm as below , drill holes for screws and use C . A
glue to stop the nuts from coming loose .
●
Fit the rudder servo and drill holes using a fine drill for the servo screws
;
drop thin C . A glue into the
holes to strengthen the wood
.
●
Using servo screws
,
fix the servo in place
;
note that the spline is towards the front of the plane