3.
Sand the area on the horn that will be glued inside the elevator.
4.
Using plenty of 30 minute epoxy fit the horn and plate into place. Use a ball joint and bolt to hold the
horn in place while drying.
REPEAT FOR THE OTHER SIDE
5.
Locate the horizontal stabilizer, use a hobby knife to remove the covering over the area that will be
glued to fuselage. It is essential that this is checked for alignment. Place the wing tube in and then
look down the fuselage to make sure it is in line. Then measure to ensure the same amount is sticking
out each side. Once happy, check again!! Then glue it to the slot with 30 minute epoxy, allow to dry.
