7
3. Insert a Wheel (93) into a Wheel Housing (43). Attach the
Wheel with a Wheel Bolt (92) and a Nut (25).
Note: Do
not overtighten the Nut; the Wheel should turn freely
.
Tip the Uprights (99) forward slightly and insert the Wheel
Housing (43) into the base of the Uprights as shown.
Attach the other Wheel (not shown) and Wheel Housing
(not shown) as described above.
99
92
93
43
25
3
4. With the help of a second person, carefully lower the
Uprights (99). Make sure that the Wheel Housings (43)
remain in the base of the Uprights.
Attach each Wheel Housing (43) with a 1” Tek Screw
(98). Next, attach the two Base Pads (97) to the base of
the Uprights (99) with 1” Tek Screws (98).
With the help of a second person, carefully raise the
Uprights (99) to the vertical position.
43
98
98
99
97
4
2. Insert the Wire Harnesses (22, 82) into the right Upright
(99).
Set the console assembly on the Uprights (99). While a
second person holds the console assembly, attach it with
four Console Bolts (86) and four Console Washers (88)
as shown. Start all four Console Bolts and then firmly
tighten them.
Console
Assembly
88
22, 82
88
86
86
99
2
Summary of Contents for GGTL09605.0
Page 26: ...26 NOTES ...
