GOLDMUND LOGOS SUKHA Active Speaker - 9
5
CONNECTIONS (Ctd.)
•
Connect the USB dongle to an USB port on your computer or the Wireless
Transmitter to the corresponding output channel of your acoustic processor.
•
If you use the USB dongle: in your computer’s audio settings, select the USB
dongle as the audio output. If you use the Wireless Transmitter: contact your
Goldmund representative who will be able to load and change the configuration file
into your acoustic processor.
The system is now set up and ready to be used. The volume is set directly on the computer
(when used with the dongle) or on the acoustic processor (when used with a Transmitter).
The LOGOS SUKHA and the associated USB Goldmund dongle are delivered prepaired
from the factory. This means that your speakers can only function with the dongle that was
paired with it. However, if you would like to do a re-pairing of the speaker with the dongle
for any reason, please follow these steps:
•
Connect the USB dongle to your computer or the Wireless Transmitter to your
acoustic processor.
•
Insert a small screwdriver into the pairing hole located on the back panel of your
speaker, just above the input RCA.
•
Gently press the internal pairing button using the screwdriver.
•
As soon as the pairing is done, the led locking led will light up.
•
The pairing is done.
In case you lose your dongle, you can order another one from your distributor who will also
pair it to your speakers.
The digital signal is treated with the Proteus technology. The LOGOS SUKHA has no
active filtering (hardware crossover).
The LOGOS SUKHA uses a full digital filtering, the crossover is made by software inside
the DSP speaker board.
Only an official Goldmund representative is able to load and change the configuration file,
do not change it by yourself.
Attention:
Due to the high gain of the LOGOS
SUKHA speaker, please make sure
that the media player is set to a low
output level, before connecting the
dongle to the computer.
