7
Installation Of Your Power Lift Chair
Model: PR445-MED
1. Remove the transformer from the transformer box (located behind the lower
outside back) and place two 9 volt batteries in transformer as shown. Place
transformer on the floor behind the chair.
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect
the power cable from the chair into the transformer as shown. Power
cable is located under the chair attached to the motor with white zip
tie. Remove zip tie, extend the cable under and out behind the chair.
L.E.D. light
L.E.D. light
From motor
To outlet
115-120V A.C.
DC Power
Bottom view of
Transformer
Transformer
Plug
Install two 9 volt batteries
in transformer for battery
backup (See page 10)
(batteries not included)
PA
TENTED
3. Align the back brackets and the seat
brackets, then push down on the seat
back until they are locked into place.
4. Recline the back of the chair to expose
the zipper.
5. Zipper the back and the seat fabric together
to eliminate the gap between them.
6. Attach the bottom of the outside back to
the Velcro on the arm cross rail.
7.
Place the chair in the desired
position in the room, keeping it 21"
away from the wall. If placing the chair
into a corner, keep it 21" from the wall as
shown. See distance chart below for your
model.
continued on next page
Zipper
