Compass Sport_SG_REVA_101014
19
REPLACEMENT INSTRUCTIONS
DRIVE WHEEL
1. Turn off power.
2. Place the power chair in drive mode.
3. Place a support under the frame so that the drive wheel is off the ground.
4. Remove the drive wheel.
Note: Make sure to retain the axle key. See figure 14.
5. Install the new drive wheel.
Note: Make sure the axle key is installed correctly in the axle slot. Also, make
sure the washer is installed facing in the correct direction, with the dimples facing toward the hub cap.
6. Remove the frame support.
7. Power on and test the power chair.
Figure 14. Drive Wheel Assembly
CASTER
1. Turn off power.
2. Place the power chair in drive mode.
3. Place a support under the frame so that the caster wheel is off of the ground.
4. Remove the cap from caster arm. See figure 15.
5. Remove the nut that fastens the caster wheel to the caster arm. See figure 15.
Note: Make sure you retain the hardware used to secure the caster assembly
.
6. Install the new caster assembly.
7. Remove the frame support.
8. Power on and test the power chair.
Figure 15. Front Left Caster Assembly shown
Axle Key
Washer
Hub Cap
