Golden Technologies Cirrus PR-508, Owner'S Manual

Page: 8 / 24

8
M
aking
P
ower
C
onneCtions
i
n
Y
our
n
ew
L
ift
C
hair
Model PR505-M26
1. Install two 9 volt alkaline batteries in the inline battery holder as shown. The
battery holder is zip tied (white) to the rear of the metal frame. Cut the white
zip tie and extend the cable under and out behind the chair.
2. Remove the transformer from the transformer box follow steps 1, 2 and 3 on
page 7 to connect the transformer to the chair and AC outlet.
3. Pull the hand control out of the magazine pocket and secure the cord into the
quick release cable clamp located above the pocket on the arm of the chair.
4. Place the chair in the desired position in the room, leaving the chair a safe
distance from the wall. See chair location on page 7 for the proper distance
from the wall.
5. Adjust the leg levelers on the bottom of the chair if necessary. Some high pile
carpets can obstruct the footrest operation by rubbing against it. Adjust the
levelers to a height above the pile.
L.E.D. light
(batteries not included)
PA
TENTED