34
X. CARE AND MAINTENANCE
Fuses
Non-Flash/Beep Code Faults
If the following faults occur, please check the appropriate fuses located inside the power
module panel or at the center of the tiller. Refer to figures 26 and 27 below for fuse
replacement and warnings.
Good Fuse Bad Fuse
Faults
•
The dash does not illuminate when the key is turned to the “on” position. The scooter
does not operate and the headlight/taillight do not illuminate.
•
The USB charging port will not charge your smart devices such as a phone or tablet.
Remedy:
Check the fuse (35 AMP) inside the power module panel located directly under
the seat. Replace the fuse with the same type and rating if the fuse is bad.
Good Fuse Bad Fuse
Fault
•
The XLR charging port is not functioning, causing the battery pack not to charge when
the off-board battery charger is connected.
Remedy:
Check the fuse (F3AL250V) inside the fuse holder located on the tiller below the
control panel. Replace the fuse with the same type and rating if the fuse is bad.
Fuses MUST be replaced with same type and rating.
35AMP Blade Style Fuse shown
3AMP Mini Glass Fuse shown
Figure 26: 35 AMP Power Module Fuse
Figure 27: 3 AMP Tiller Fuse
Spare
Fuse
Fuse
