Golden Eagle Talon, Operating & Installation Manual

Page: 16 / 36

OPERATION
The blowers and automatic fuel supply are controlled from a panel on the left ‐ hand side of the stove.
The control panel functions are as follows.
Button Controls
ON/OFF SWITCH

When pushed the stove will automatically ignite. No other
firestarter is necessary. The igniter will stay on for at least 10 and
up to 15 minutes, depending on when Proof of Fire is reached.
The fire should start in about 5 minutes.

The green light located above the On/Off button (in the
On/Off box) will flash during the ignition start ‐ up period. (See
figure 12)

The Heat Level Advance is inoperable during the ignition start
period. When the green light continuously stays on the Heat Level
Advance can be adjusted to achieve the desired heat output.
If the stove has been shut off, and you want to re ‐ start
it while it is still warm, the “on/off” button must be held
down for 2 seconds.
FUEL FEED BUTTON

When the “Fuel Feed” button is pushed and held down the
stove will feed pellets continuously into the burnpot.

While the stove’s auger system is feeding pellets the green
light (in the “Fuel Feed” box) will be on. (See figure 11)
DO NOT USE THE FUEL FEED BUTTON DURING NORMAL OPERATION BECAUSE IT
COULD SMOTHER THE FIRE AND LEAD TO A DANGEROUS SITUATION.
HIGH FAN SWITCH

The room air fan speed varies directly with the feed rate. The “HIGH FAN” switch overrides this
variable speed function. It will set the room air blower speed to high at any feed rate setting.

When the “HIGH FAN” button is pushed the room air fan will switch to its highest setting.

When this button is pushed again the room air fan will return to its original setting based on the
Heat Level Advance setting.
Figure 11