Golden Eagle MONROE, Operating & Installation Manual

Page: 10 / 36

Combustion Air Supply
A 2” inside diameter metallic pipe, either flexible or
rigid, may be attached to the inlet at the stove’s rear
(refer to figure 3). A rodent guard (minimum ¼” wire
mesh)/wind hood must be used at the terminus (refer
to figure 4). All connections must be secured and
airtight by either using the appropriately sized hose
clamp and/or UL ‐ 181 ‐ AP foil tape.
For mobile home installations only : 2” inside
diameter pipe may be used for the first 5 feet of
combustion air supply run; from 5 to 10 feet use 2 ¾”
or larger inside diameter pipe.
Sources of Outside Combustion Air
1. In fireplaces

Chimney top.

Ash clean out door.
2. For freestanding installations

A hole in floor near stove rear terminating only in a ventilated crawl space.

A hole in the wall behind the stove.
If outside air is not used, it is important
that combustion air is easily available to
the air inlet. A closeable outside air
register can be used in tightly insulated
homes.
FOR A MOBILE HOME INSTALLATION THE
STOVE MUST BE CONNECTED TO AN
OUTSIDE SOURCE OF COMBUSTION AIR.
FOR MOBILE HOME INSTALLATIONS NO
COMBUSTION AIR SUPPLY MAY EXCEED 10 FEET.
Electrical Installation
Voltage variations can lead to serious performance problems. The electrical system is designed for
120V AC with no more than 5% variation. Golden Eagle Stove Company cannot accept responsibility
for poor performance or damage due to inadequate voltage. If connected to an older two ‐ prong
outlet, a separate ground wire should be run to a proper ground (refer this to a qualified technician).
Always route the electrical cord so that it will not come into contact with any hot part of the stove.
DO NOT CONNECT THE UNIT TO A GFCI SOCKET OR CIRCUIT.
We recommend connecting to a good quality surge protector that is plugged into a
standard three ‐ prong, 120V, 60 Hz electrical outlet.
Figure 3
Figure 4