13
4. During your sauna session, set-up time will count down the minutes one by one. When the time remaining is 5
minutes, the buzzer will make a warning sound for approximately 15 seconds letting you know you only have 5
minutes remaining. At this point, you can let the time run out or adjust the time by pressing the up/down arrows under
the TIME DISPLAY. If you do choose to adjust the time, the control panel will flash and the emitters will stop
generating heat. Once you set the time to the desired setting, then press the START/WORK button twice and the
control panel will stop flashing and heat will began coming from the emitters once again.
5. Heating times do vary. Generally, it will take approximately twenty to thirty minutes to preheat the sauna to 50
degrees Celsius / 122 degrees Fahrenheit. When the ambient temperature is low, heating requires additional time.
For the first few times of use, you may use 46 degrees Celsius / 115 degrees Fahrenheit as a reference starting point
for a time period of about 15 minutes (this represents the actual time you are in the sauna at the desired
temperature). As you become more comfortable and familiar with the sauna, you can increase the temperature and
time period according to personal preference.
6. When the temperature is at the set-up value, the digital control will maintain the set temperature.
The WORK light will remain on and the HEAT light will turn off. The emitters will stop generating heat. Once the
inside temperature drops approximately 4 degrees, the HEAT light will turn back on and heat will again be
generated by the emitters. With the digital control, the inside temperature will always remain around the set-up
value.
7. Reading lamps and/or roof lamps and/or color therapy lamps are operated by pressing the respective buttons
located towards the center of the control panel. These lamps are offered on some models and are not available on
all models.
8.
Chromotherapy/Color Therapy Lighting (optional)
can be operated as follows. First, you
will need to install the battery. Once the battery has been inserted into the remote, you are ready to operate
the chromotherapy/color therapy lighting system. Press the READING LIGHT button on the sauna control panel.
The white light will come on. While pointing the remote at the ceiling light, you can press any of the colors on the
remote and that color will be displayed. You can use the SHADE button on the remote to go through a sequence
of colors. If you want to turn the light off during your sauna session, you can press the POWER button on the
remote.
Pleas
e note: You must be inside the sauna room for the remote to work. Remote may vary in
appearance.