3
Do not run heater cord under carpet. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Route cord away from traffic
areas.
Do not use the heater in bathrooms, laundry rooms, or similar indoor locations.
Turn off heater before unplugging.
Do not insert any foreign object or allow foreign object to enter the ventilation opening
or exhaust opening as this may cause electric shock, fire, and/or injury.
Never block the air intake or exhaust opening in any manner as this could lead to fire.
Do not locate heater, when in use, immediately below a receptacle.
Never operate heater in or around a bathtub, shower, or swimming pool.
Only open heater if instructed by an authorized representative of the manufacturer. There
are limited user-serviceable parts inside.
Use heater only as described in this manual. Any other use is not recommended by the
manufacturer as it may lead to fire, electric shock, and/or series physical injury or death.
Heater Specifications
Dynamic
Infrared Heater
Model# DYN-HTR-1500-200
Carton Size: 17.3 in x 15.4 in x 20.9 in Thermostat: Electronic Analog
Heater Size: 14.9 in x 13 in x 17.7 in
Fan System: Cross Flow Fan
Net Weight: 25 lbs
Fan Noise Level: 46 db
Gross Weight: 28 lbs
BTU: Approximately 5100
Cabinet: Wood, Dark Oak
Delayed Start Function
Power Cord: 5.8 ft / 16 gauge
Remote Control
Heating Elements: 1 Infrared Quartz Bulb
“HI” Function: 1500 watts
2 Resistance Wire Panel System (RMS)
“LOW” Function: 750 watts
Power Requirement: 120V 15AMP
Washable Filter
Heating Elements Life Expectancy Potential: Rated 20,000 hrs
Power Requirement: 120V 15AMP
Heat Type: Quartz Infrared Heat
Warranty: Limited 1-Year Parts Warranty
How It Works
The Dynamic Infrared Heater works with your in-home furnace to provide supplement heat. In
short, room temperature air circulates from the rear of the Dynamic Infrared Heater, passes
through a highly efficient filter, enters a chamber that houses the Infrared Quartz Bulbs, and exits
as heated air from the Diathermanous Copper Plate constructed on the front of the unit. The
Dynamic Infrared Heater ideally heats a room of 500 to 700 square feet, but can be used to heat
up a single room size up to 750 square feet depending on the ambient temperature. And it does all
this with a noise level below 46db. The Dynamic Infrared Heater is not for use as the primary/sole
heating system.
