ASSEMBLY
15
FILLING THE WATER RESERVOIR (Fig. 11)
• Raise the 45° vertical fence approx. 45° and remove.
• Push water reservoir plug into hole firmly.
• Fill the reservoir with water only until water can drain from the opening in the
plug.
• Ensure that water just cover the disc edge (no more than ¼ of the disc is
submerged in water).
• Replace 45° vertical fence.
TO CHANGE RESERVOIR WATER
• Unplug tile saw.
• Remove the water reservoir plug and empty into a bucket do not allow water to
splash onto ground or around machine.
• Discard waste water in accordance with local regulations.
CAUTION!
• Fill the product with water only until water can drain from
the opening in the plug. During use the water level must
never drop below the MIN marking (1). (Fig. 11)
• Product damage! Fill the tank only with clear water.
Never use chemicals or cleaning agents. This can cause
irreparable damage to the product.
CONNECTION TO THE ELECTRICAL SUPPLY
Before switching on, make sure that the voltage of the mains supply is the same
as indicated on the rating plate. This product is designed to operate on
120V~60Hz.
Connecting it to any other power source may cause damage.
This appliance must be properly grounded. If in doubt, please consult a qualified
electrician. The mains supply shall be fed via a 10 amp min. fuse. Put the tile saw
on a clean, stable and flat surface.
WARNING !
Before switching the tile saw on, make sure that you have read and
understood all of the safety instructions. Make sure that the tile saw is unplugged
when the tile saw is not being used or adjustments are being made.
WARNING !
The disc will continue to rotate for a few
seconds after the machine has been switched off. Wait for the disc to stop before
removing the workpiece or making any adjustments.
Stop the machine immediately if there is undue vibration or some other fault. If
this situation continues, check the machine to find the origin of the fault.
fig.11
1
MIN
MIN
