13
ASSEMBLY
INSTALLATION OF THE PROTECTIVE GUARD
(Fig. 4)
• Loosen the locking knob (1) and remove the locking knob,
flat washer (2) and hex bolt (3) from the upper protective
guard (4)
• Align upper protective guard (4) with cutting disc and slide
over metal bracket (5). Line up througn holes in upper
protective guard with slot in metal bracket.
• Install hex bolt (3) through upper protective guard and
metal bracket. Put the flat washer (2) onto bolt before
the thread locking knob (1) and tighten the locking knob.
• Cover the cutting disc with the upper protective guard (4).
• Ensure that upper protective guard (4) can move freely
and that it cannot touch the cutting disc.
INSTALLATION OF THE PARALLEL GUIDE (Fig. 5)
• Attach the rear end of the parallel cutting guide (1) to the
rear of the working table.
• Push the spring (2), clamp (3) and flat washer (4) onto
thread (5).
• Screw locking knob (6) onto thread (5) and turn it
clockwise to tighten securely.
ADJUSTING THE PARALLEL CUTTING GUIDE
• Gently turn locking knob on parallel cutting guide
counter-clockwise to loosen.
• Use parallel cutting guide scale, located on front and rear
of working table, to set parallel cutting guide to desired
width of cut.
• Turn locking knob clockwise to tighten securely.
MITER OR DIAGONAL CUT (Fig. 6)
• Mitre cutting can be performed by using the mitre
cutting guide. The angle can be adjusted from 0° to 45°
by unscrewing the plastic screw.
fig.6
fig.4
1 2
1 2 4
4
3
5
3
fig.5
1
5 2 3 4 6
WARNING !
The metal bracket must always be aligned to the cutting disc so that it does not
Interfere with material being cut.
WARNING !
Product damage! Do not over-tighten hex bolt (3) and locking knob (1). The upper
protective guard (4) must be free to rise and fall as the workpiece is pushed
toward the cutting disc.
