![background image](http://html.mh-extra.com/html/goldair/platinum-gppac250/platinum-gppac250_operating-instructions-manual_2239848013.webp)
Operating your Portable Air Conditioner
DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit.
If the reservoir is full, both
the compressor and motor will stop and the unit will buzz (you can
press any button to stop the buzz). The Water Full indicator will flash.
To make the cooling work again, please empty the water by one of the following ways.
•
Turn off the air conditioner and avoid moving
it when full.
•
Position a container (a water tray for
example) underneath the drain hole.
•
Remove the drain knob & rubber plug from
the drain hole and allow the water to drain
out.
•
When the container is almost full, replace the
rubber plug in the drain hole and empty the
water tray.
•
Repeat until the unit is emptied.
•
Replace the rubber plug and tighten the drain
knob firmly.
•
Switch on the unit - the full water indicator
should now be off.
CONTINUOUS DRAINAGE
•
Remove the drain knob and rubber plug and
retain for future use.
•
Connect the drain tube supplied to the water
outlet as shown and locate the other end into a
drain.
•
The drain tube may be extended by adding an
extension tube and using a suitable connector.(
Not supplied)
•
If you want to extend the water tube, you can
connect it with another tube (OD: 18mm)
•
The drain must be below the outlet level.