Operating your Radiant Heater
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation.
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the
heater to remove dust and dirt.
The reflector body can be cleaned by using a dry
duster or soft brush through the grill, taking care not
to damage the glass tubes.
Never use solutions such as benzene, thinners or
polishing agents.
In order to get the maximum heat, the reflector must
be kept clean.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Ensure the heater is dry before plugging back into
the mains supply.
CAUTION
The Radiant Heater generates heat during use.
Proper precautions must be taken to prevent the risk
of burns, scalds, fires or other damage to persons.
WARNING
The heater must not be used if the glass tubes
are damaged
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
IMPORTANT! NEVER COVER THIS HEATER
WARNING Keep all objects at least 1 metre from
the front, sides and rear of the appliance.
ASSEMBLING YOUR HEATER
The heater comes with 2 wheel plates and castors
that need to be fitted to the heater before using. The
screw pack to attach the feet to your heater will be
taped to either one of the feet for your heater, or
taped to the plug head.
HEAT CONTROL SWITCH
The control switch positions are:
“0”
= OFF
= Low Heat
= Medium Heat
= High Heat
= Maximum Heat
Check that the heat control switch is set to Off
position before plugging the heater into the mains
supply. For greater economy, use the High Heat
setting initially and then switch to the Low Heat
setting.
THERMOSTAT
Turn the thermostat knob clockwise until you reach
the maximum temperature on the graduated scale.
When the desired room temperature is reached,
slowly turn the knob anti-clockwise until the heater
turns off (you will hear a click). The heater will now
cycle on and off to maintain the set temperature.
SAFETY DEVICE
A safety tip over device is built into the appliance for
added safety. This device will automatically turn the
appliance off if the appliance is not in the appropriate
operating position.
Do not attempt to dismantle the heater. There are no
user serviceable parts. For service or repair, contact
an authorised electrical service technician.
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
