Operating your Convector Heater
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
SAFETY DEVICE
This appliance has two protection devices. The first
device automatically disconnects & reconnects the
appliance at a pre-set temperature.
The second safety device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse (it is non resettable).
IMPORTANT! NEVER COVER THIS HEATER
CLEANING YOUR HEATER
The heater requires regular cleaning to ensure trouble
free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool down
completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the
heater to remove dust and dirt.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Never use solutions such as benzene, thinners or
polishing agents.
Ensure the heater is dry before plugging back into the
mains supply.
Do not attempt to dismantle the heater. There are no
user serviceable parts. For service or repair, contact
an authorised electrical service technician.
CAUTION: This heater generates heat during use.
Proper precautions must be taken to prevent the risk
of burns, scalds, fires or other damage to persons
WARNING: Do not use this heater with a separate
programmer, separate timer, separate remote-control
system or any other device that switches the heater
on automatically.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase.
WARNING Keep all objects at least 1 metre from
the front, sides and rear of the appliance.
PLEASE NOTE: As this product is fitted with a
Timer, the Timer has been set to the
“ON”
position. Please refer to the Timer section for
setting instructions.
ASSEMBLY OF THE HEATER
Before using the heater the feet (supplied separately
in the carton), must be fitted to the unit. These need
to be attached to the base of the heater using the
screws provided, taking care to ensure that they are
located correctly in the bottom ends of the heater side
mouldings. The screw pack to attach the feet to your
heater will be taped to either one of the feet for your
heater, or taped to the plug head.
HEAT CONTROL SWITCH
The control switch positions are:
0
- Off
750W
- Low Heat
1250W
- Medium Heat
Both
- High Heat
Check that the heat control switch is set to Off
position before plugging the heater into the mains
supply. For greater economy, use the High Heat
setting initially and then switch to the Low Heat
setting.
THERMOSTAT
Turn the thermostat knob clockwise until you reach
the maximum temperature on the graduated scale.
When the desired room temperature is reached,
slowly turn the knob anti-clockwise until the heater
turns off (you will hear a click). The heater will now
cycle on and off to maintain the set temperature.
FAN FUNCTION
In addition to the three heat settings, there is a fan
with a separate On/Off switch located on the control
panel. The Fan function is for distributing heat into
the room at a faster rate.
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
