WARNING: THIS IS A DOUBLE SIDED HEATER.
Keep all objects at least 1 metre from the front,
sides and rear of the appliance.
WARNING: In order to avoid overheating, do not
cover the heater.
WARNING: Never leave this heater unattended.
WARNING: Take care in positioning your heater,
using the timer will mean the heater will come on
automatically. Fire may result if placed next to
combustible material.
Note: When the heater is turned on for the first
time, it may release a slight, odour or smoke.
This odour or smoke is a normal occurrence
caused by the initial heating of the internal
heating elements and should not occur again.
HEAT CONTROL SWITCH
The control switch positions are:
I
- Low heat
II
- Medium heat
I+II - High heat
Check that the heat control switch is set to Off
position before plugging the heater into the mains
supply. For greater economy, use the High Heat
setting initially and then switch to the Low Heat
setting.
THERMOSTAT
Turn the thermostat knob clockwise until you reach
the maximum temperature on the graduated scale.
When the desired room temperature is reached,
slowly turn the knob anti-clockwise until the heater
turns off (you will hear a click). The heater will now
cycle on and off to maintain the set temperature.
Always choose a safe location for the appliance, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the unit
before use. This appliance requires no installation, it should be used solely as a
portable appliance.
Operating your appliance
TIMER
The heater will always be on when the MODE
switch is in the
“I” position.
The heater will always be off when the MODE
switch is in the
“O” position.
To set the Timer; set the MODE switch to the Timer
position.
(This function can only be used once a heat level
has been selected ; see thermostat section).
You must set the time prior to programming the
Timer. To do this; turn the outer dial of the timer in
a clockwise direction until the time of the day (24-
hour
clock)
corresponds
with
the
triangular
marking. Example if it is 2pm (1400 hours) then set
the triangular mark in line with 14. One complete
turn of the dial corresponds to 24 hours.
There are 96
“riders”, positioned around the dial,
each rider represents 15 minutes.
Where all the
“riders” are pushed to the outside of
the timer the heater will be ON continuously.
To set a specific time for example:
If you want the heater to be on from 6pm to 10pm,
then set all the riders from 18 to 22 (1800 hours to
2200 hours) to the outside of the rim and all other
riders to the inside of the timer. The unit will then
turn on automatically at 6pm and off again at 10pm.
WARNING! Take care in positioning your heater,
using the Timer will mean the heater will come on
automatically.
Fire may result if placed next to
combustible material.
Mode switch positions
OFF
TIMER ON
OVERRIDE
Indicates actual time
Riders pushed to the
outside rim to turn
ON
