OPERATING YOUR HEATER
Before operation place the product on a flat, stable, heat-resistant surface. Plug the power cord into a
standard 230/240 volt AC electrical outlet.
•
To turn the heater on set the MODE switch to I.
•
For LOW heat turn the power setting knob to the I position.
•
For MEDIUM heat turn the power setting knob to the II position.
•
For HIGH heat turn the power setting knob to the III position.
THERMOSTAT
•
Once you have selected the desired power setting, turn the thermostat control clockwise as far as it
will go and the indicator light will illuminate.
•
Leave the thermostat control at its maximum position until the desired room temperature is reached.
•
Slowly turn the thermostat knob anti-clockwise until the heater shuts off. (Indicator light goes off.)
•
Leave thermostat setting at this position. The heater automatically cycles on and off to maintain the
chosen room temperature, (the indicator light also cycles on and off). As long as a power setting is
selected (and there is power supplied to the heater) the heater operates.
TIMER
•
This heater will not operate unless the timer has been set.
•
Turn the outer dial of the timer in a clockwise direction until the time of the day (24-hour clock)
corresponds with the triangular marking. One complete turn of the dial corresponds to 24 hours.
•
There are 96 “riders”, positioned around the dial, each rider represents 15 minutes. When the “riders”
are pushed out the heater will turn on when they travel past the triangle marking on the casing. You
need to push out the riders to correspond with the time the heater is to turn on.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).
SUPPORT AND TECHNICAL ADVICE
North Shore City, Auckland, New Zealand
Monday – Friday 8am-5pm
Phone: 0800 232 633
Website: www.goldair.co.nz
SAFETY DEVICE
~ This appliance has two protection devices:
The first device, automatically disconnects & reconnects the appliance at a preset temperature,
The second safety device disconnects the appliance permanently in case of overheating, by means of a
thermal fuse. (It is non resettable)
IMPORTANT! ~ NEVER COVER THIS HEATER!
Covering the heater will cause activation of the non resettable safety fuse.
