Operating your Micathermic Heater
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
WARNING: THIS IS A DOUBLE SIDED HEATER.
Keep all objects at least 1 metre from the front,
sides and rear of the appliance.
Note: When the heater is turned on for the first
time, it may release a slight, odour or smoke. This
odour or smoke is a normal occurrence caused
by the initial heating of the internal heating
elements and should not occur again.
HEAT CONTROL SWITCH
Check that the Power Switch at the back of the
heater is set to the Off position before plugging the
heater in and turning on the mains supply.
Turn the Power Switch at the back of the heater to
the
“I” position.
Press the Power button on the control panel to turn
the heater on, the unit will begin on high heat.
The LED will display the current room temperature
and both power indicators will be lit.
Press the
“-” button and the heater will begin to
operate in Low Heat.
Press the
“+” button and the heater will operate in
High Heat mode.
The corresponding indicator light will display on the
LED panel to show Low or High Heat operation.
THERMOSTAT
Press the Temperature button then use the
“+” and “-”
buttons to adjust the temperature to your desired
setting (from 5-36°C). Once you have set the desired
temperature, the LED will display the room temperature
again and will rise as the room temperature increases.
The heater will now cycle on and off to maintain the set
temperature.
How the set temperature is maintained:
If the room temperature is higher than the set
temperature, the heater shuts Off automatically.
If the room temperature is lower than the set
temperature, the heater automatically switches itself
back On.
TIMER
Press the Timer button then use the
“+” or “-” buttons to
adjust the length of time from 1
– 18hours that you
would like the heater to run for before turning off. Each
press of the
“+” or “-” button will adjust the length of
time by 30 minute increments.
To turn off the Timer function, set the Timer back to
“0”
hours or simply turn the unit off.