Fitting your Goldair Electric Blanket
FITTING YOUR GOLDAIR TIE DOWN ELECTRIC BLANKET (GST Model)
Place the Electric Blanket onto the mattress with the controller/s at the HEAD END but towards the
foot end of the bed.
The control switches should be below the Electric Blanket at the head end.
Unroll the tie tapes and pass the tapes under the bed as shown in the diagrams below.
Ensure the heating wires
do not extend under pillows or hang over the sides
. Pass the middle
tie cord under the mattress and through the middle loop on the opposite side (Fig.1).
Pass end of tie tape under the corresponding bottom corner of the mattress (Fig. 2) up through the
centre loop of blanket (Fig. 3) and down under opposite corner of mattress and then through side
loop on opposite side of the blanket (Fig 4).
Repeat this process at the other end (Fig. 5).