CONTROLS
The controls shown below are located on the rear of
the heater.
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
CAUTION: DO NOT OPERATE ON DEEP PILE
CARPETS AS THIS MAY RESTRICT THE AIR
FLOW THROUGH THE HEATER
USING THE HEATER
Plug the heater in to a suitable main outlet (see rating
label on unit for power requirements).
Switch “1” Power + Flame
Set this switch to position
“
”
to turn the unit on
and this will also start the flame effect.
Setting this switch to
“O
”
turns the product OFF.
Switch “2” Heater Function ON/OFF
Turn on switch to start heating.
Turn off switch to stop heating
Switch “3” Heat Settings
Turn switch to position ‘-’ for low heat or ‘=’ for high
heat.
Overview of your Flame Effect Heater
This heater is equipped with two manual heat settings and flame effect
only setting.
Note: When the heater is turned on for the first time, it may release a slight, harmless odour or
smoke. This odour or smoke is a normal occurrence caused by the initial heating of the internal
heating elements and should not occur again.
TECHNICAL SPECIFICATION
Model No: GFE200R, GFE200B, GFE200W
Power Supply: 220-240V, 50Hz AC only
Power: 1600W-1900W
SAFETY DEVICE
This appliance has two protection devices:
The first device will automatically turn the appliance
off if the appliance is not in the appropriate operating
position.
The second device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse. (It is non resettable)
IMPORTANT! NEVER COVER THIS HEATER!
Covering the heater will cause activation of the non
resettable safety fuse.
CARE AND CLEANING
Do not attempt to dismantle the heater. There are
no user serviceable parts. For service or repair,
contact an authorised electrical service technician.
The outer shell may be cleaned with a soft, damp
cloth. You may use a mild detergent if necessary.
The front glass panel can be cleaned with a good
quality glass cleaner if required. After cleaning, dry
the unit with a soft cloth.
CAUTION: DO NOT let liquid enter the heater.
CAUTION
The heater generates heat during use. Proper
precautions must be taken to prevent the risk
of
burns, scalds, fires or other damage to persons
.
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
1.
Power Switch and
Flame Effect
2.
Heating ON/OFF
3.
Heat Setting
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland, New Zealand
Monday
– Friday 8am-5pm
Phone: 0800 232 633
Website: www.Goldair.co.nz