General Care and Safety Guide
CONTENTS
1 x Goldair panel heater
1 x Wall mounting accessories pack
-2 x drill bits (1 x 7mm for plasterboard or wooden
walls, 1 x 8mm for drilling masonry)
- 4 x rail fittings
- 4 x screw bolts
- 4 x bolt caps
NOTE: Please ensure you use the correct drill bit
for the correct material. Please contact your local
hardware retailer or builder for advice.
OVERVIEW OF YOUR GOLDAIR PANEL
HEATER
Your Goldair Panel Heater will provide controlled
background warmth by heating your room. The
surface of this Panel Heater can be painted with
good quality paint (acrylic or enamel).
OPERATING INSTRUCTIONS
Before plugging in and using your new Goldair
panel heater, check all surfaces to ensure the
heater is not damaged in any way.
After checking this, plug your heater in a mains
voltage plug corresponding to the rated output.
Use the On/Off Power Switch along the side of
the heater to turn your heater on.
SAFETY FEATURE
This heater is fitted with a thermal fuse in case
of overheating which is located inside the
construction of the heater. If this thermal fuse
operates it will turn the heater off but the light in
the power switch will remain on to let you know
there is still power going into the heater. In the
event that this happens, turn the heater off at
the switch and the wall socket and unplug it then
contact our Customer Service team.
CARE AND CLEANING
Do not attempt to dismantle the Panel Heater.
There are no user serviceable parts. For service
or repair, contact an authorised electrical service
technician.
The heater requires regular cleaning to ensure
trouble free operation. Before cleaning, switch
off the heater and allow it to cool. Disconnect
the mains power supply cord. The outside can
be cleaned by wiping it over with a soft dry cloth.
NOTE: Do not use abrasive cleaning agents
or polish, this can damage the surface and
finish.
To remove the unit from the wall, simply remove
the bolt caps, unscrew the bolts with a screw
driver and then take the heater down.
For short term non-use, simply turn off the unit
with the power switch on the side of the heater
and disconnect the mains power supply at the
wall; for long term non-use, remove the unit from
the wall - simply remove the bolt caps, unscrew
the bolts with a screw driver and then take the
heater down
.
IMPORTANT! NEVER COVER THIS HEATER!
CAUTION
This heater generates heat during use. Proper
precautions must be taken to prevent the risk
of
burns, scalds, fires or other damage to persons
.
WARNING Keep all objects at least 1 metre
from the front of the appliance.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
PLEASE NOTE: As the GECO201 model is fitted with a timer, the timer has
been set to the
“ON” position. Please refer to the timer section for setting
instructions.
Summary of Contents for GECO200
Page 1: ......
